Go to the first, previous, next, last section, table of contents.


Tandem ST2000

may be used with a Tandem ST2000 phone switch, running Tandem's STDBUG protocol.

To connect your ST2000 to the host system, see the manufacturer's manual. Once the ST2000 is physically attached, you can run:

target st2000 dev speed

to establish it as your debugging environment. dev is normally the name of a serial device, such as `/dev/ttya', connected to the ST2000 via a serial line. You can instead specify dev as a TCP connection (for example, to a serial line attached via a terminal concentrator) using the syntax hostname:portnumber.

The load and attach commands are not defined for this target; you must load your program into the ST2000 as you normally would for standalone operation. reads debugging information (such as symbols) from a separate, debugging version of the program available on your host computer.

These auxiliary commands are available to help you with the ST2000 environment:

st2000 command
Send a command to the STDBUG monitor. See the manufacturer's manual for available commands.
connect
Connect the controlling terminal to the STDBUG command monitor. When you are done interacting with STDBUG, typing either of two character sequences gets you back to the command prompt: RET~. (Return, followed by tilde and period) or RET~C-d (Return, followed by tilde and control-D).


Go to the first, previous, next, last section, table of contents.