Go to the first, previous, next, last section, table of contents.


A29K

set rstack_high_address address
On AMD 29000 family processors, registers are saved in a separate register stack. There is no way for to determine the extent of this stack. Normally, just assumes that the stack is "large enough". This may result in referencing memory locations that do not exist. If necessary, you can get around this problem by specifying the ending address of the register stack with the set rstack_high_address command. The argument should be an address, which you probably want to precede with `0x' to specify in hexadecimal.
show rstack_high_address
Display the current limit of the register stack, on AMD 29000 family processors.


Go to the first, previous, next, last section, table of contents.