unexpand: Convert spaces to tabs

unexpand writes the contents of each given file, or standard input if none are given or for a file of `-', to standard output, with strings of two or more space or tab characters converted to as many tabs as possible followed by as many spaces as are needed. Synopsis:

unexpand [option]... [file]...

By default, unexpand converts only initial spaces and tabs (those that precede all non space or tab characters) on each line. It preserves backspace characters in the output; they decrement the column count for tab calculations. By default, tabs are set at every 8th column.

The program accepts the following options. Also see section Common options.

`-tab1[,tab2]...'

`-t tab1[,tab2]...'

`--tabs=tab1[,tab2]...'

If only one tab stop is given, set the tabs tab1 spaces apart instead of the default 8. Otherwise, set the tabs at columns tab1, tab2, ... (numbered from 0), and leave spaces and tabs beyond the tabstops given unchanged. If the tabstops are specified with the `-t' or `--tabs' option, they can be separated by blanks as well as by commas. This option implies the `-a' option.

`-a'

`--all'

Convert all strings of two or more spaces or tabs, not just initial ones, to tabs.

Go to the first, previous, next, last section, table of contents.